How do you make coin rings with the design on the outside? Everything I have found only shows how the design winds up on the inside (http://cleanstream.net/mirrors/coin_ring… and http://homepage.mac.com/johnhuber/coinri…
I know the design can be put on the outside though because I’ve seen them for sale (http://cgi.ebay.com/1904-barber-half-dol… and http://www.libraryshop.org/usicoje.html)…
I can’t figure out how this is done so any help you can give me would be greatly appreciated. Pictures would be wonderful too!
February 9th, 2010 at 5:57 pm
http://www.thelibraryshop.org/usicoje.html
Here are some pictures. You punch out the middle of the coin and bend the annulus around ball bearings until it is ring shaped.